Alt.Binz forum
New Alt.Binz versions => Bugs => Topic started by: domdom on November 15, 2009, 07:40:15 pm
-
PAR2 is d/l'ed ok, no repairing is necessary (checked with Quickpar) but no UNRAR?
In order to investigate and provide feedback, is there any reasons why it wouldnt unrar?
And while I am at it, is there a way to start unraring manually?
thanks!
-
PAR2 is d/l'ed ok, no repairing is necessary (checked with Quickpar) but no UNRAR?
In order to investigate and provide feedback, is there any reasons why it wouldnt unrar?
And while I am at it, is there a way to start unraring manually?
thanks!
1.) look in the log there might be an answer
2.) yes rightclick menue-> unrar
-
Right-click > Unrar ... apologies this is so simple I didnt even check it ...
BUT no effect when I do it ...
when I unrar manually, it is all good ...
As far as the log is concerned ... nope nothing ... I will keep digging
-
There is a bug where the PAR2 processes can fail when a previous attempt to unrar a rar'd NZB from autoimport folder has gone kaplooey, iirc. Solution: exit & restart Alt.Binz, then recheck everything in the PAR2 tab.
-
There is a bug where the PAR2 processes can fail when a previous attempt to unrar a rar'd NZB from autoimport folder has gone kaplooey, iirc. Solution: exit & restart Alt.Binz, then recheck everything in the PAR2 tab.
mmmm not using that feature (autoimport), just importing from one of the tab in AltBinz, but thanks.
-
Nevertheless, if something causes the PAR2 processes to hang, only a restart will shift things. You may then need to hunt down the culprit. Did it stop working at a particular point in the past? This is of course assuming that you have Unrar properly configured in Setup.